How to splice Govee light strip

In this article, I explain how to splice a Govee light strip.

Perhaps you want to have more than one light strip connected together using the same power adapter. This is simple to accomplish by using the Govee LED Light Strip Connectors Kit you can purchase on stores such as Amazon.

How to splice and extend the Govee light strip

To splice and extend the Govee light strip you only need a scissor and a T-shaped strip connector. Follow the steps below to get the job done. 

  • Locate the strip light cutting mark;
  • Use a scissor to cut the strip;
  • Remove the light strip rubber protection;
  • Get the connector ready to insert the light strip;
  • Align the 4-pin connector with the strip light pins;
  • Push the light strip to insert it into the connector;
  • Close the connector's clip;
  • Repeat the process for the other light strips;
  • Connect the strip light to power and test it.
  • And it's done.

    It's pretty easy, and you can get it done in less than 5 minutes.

    Cut the light strip

    Cut Govee Light Strip

    Source: Govee.com

    Remove the rubber protection

    Govee- waterproof cover

    Insert the light strip into the connector

    Govee Lights Connector

    Close the clip.

    Close the connector clip

    After connecting the Govee ligth strip, you just need to use the power adapter to test it. If something goes wrong just go over the process again.

    I hope this article can help you; please share it with your friends.

    Previous Post
    RetrofitKit
    ADT

    Are ADT sensors compatible with Ring?

    Next Post
    Ring Chime Pro
    Ring

    How To Reset the Ring Chime Pro